HOW TO USE

Before application of Epoxy, ensure the tile adhesive has set firmly. Remove any loose or foreign material from the grout joints and ensure the grout joints are clean and dry.

Epoxy is a three component system for onsite mixing. Initially add the epoxy resin to the epoxy hardener in a clean container and mix thoroughly. To this mix while stirring gradually add the joint filler powder and mix this until lump free uniform color is achieved.

Using a rubber squeegee, press the grout firmly into the joints, ensuring that the joints are completely filled. Remove excess grout from the surface of tiles with the rubber Squeegee using a diagonal motion. Clean off the surplus grout from the joints and surface within 10-15 minutes. Use the dump sponge in a circular motion and keep it relative to the surface to achieve the flush joint. Do not allow water to flow or run into upgrouped joints.

Easy to use.

Ideal for both interior & exterior application.

High strength.

Chemical resistance.

Good abrasion resistant.

1kg & 5kg bucket

12 months from the date of manufacturing.

Store unopened in normal & dry condition.

Do not add water into the Epoxy.

Do not apply on wet/dump tile joints

Do not over-mix the material.

Ensure adequate ventilation during application in working place.

Do not apply Epoxy at temperature above 50'C.

Do not allow the residue to remain on the surface more than 24 hours.

Keep out of reach of children.

As parameters such as temperature, humidity and water addition change from site-to-site, the above instructions should be taken only as a general guidelines. Performance of product depends on strict adherence to Adobe Chemicals guidelines. Adboe Chemicals will not be responsible for failure due to improper usage/applications. The coverage/yield is given for guidance only and actual field trials are recommended to ascertain the exact coverage/yield.